Worldwide Beekeeping

Beekeeping => General Beekeeping => Topic started by: D1ckyd00 on May 20, 2014, 11:05:01 am

Title: Reversing the deeps (brood boxes)
Post by: D1ckyd00 on May 20, 2014, 11:05:01 am
Hello Im new into beekeeping and I have been doing some reading, and I would like some opinions or info on reversing the deeps.

From what I have read is that when you add a new deep you should put it on the top of the intial deep and then reverse them after the queen has started laying in the upper deep.  Am I reading this correctly or am I misunderstanding.

Thank you for your opinions and info.

Dickydoo
Title: Re: Reversing the deeps (brood boxes)
Post by: pistolpete on May 20, 2014, 11:11:13 am
There was a pretty good discussion on this a couple of months ago.   There is no general agreement on this.  Basically do it if the bees need it..  If there is a honey cap over the brood in the top box, then it's a bad idea to reverse.  If you have a brood area that spans the two deeps, then it's also a poor idea to break it up.    Reversing is usually done in the spring when bees are only in the top of the two boxes.
Title: Re: Reversing the deeps (brood boxes)
Post by: D1ckyd00 on May 20, 2014, 03:55:00 pm
Ok thank you now Im understanding do it in the spring if at all.

Dickydoo
Title: Re: Reversing the deeps (brood boxes)
Post by: tbonekel on May 20, 2014, 05:42:59 pm
I went into this spring with bees in one deep.  As they grew, I just added the second deep on top and the queen eventually moved up. Now she goes between the deeps looking for empty cells to lay in. I will probably do the reversing next spring as well.
Title: Re: Reversing the deeps (brood boxes)
Post by: Bsweet on May 20, 2014, 11:37:15 pm
Normally done in the spring "if needed". Some queens get in the upper deep and stay there and the hive may swarm due to over crowding even thou the lower box is empty. The boxs are reversed to give her room to move up. Some keeps reverse and some don't. Jim
Title: Re: Reversing the deeps (brood boxes)
Post by: riverbee on May 21, 2014, 01:50:39 pm
"From what I have read is that when you add a new deep you should put it on the top of the intial deep and then reverse them after the queen has started laying in the upper deep.  Am I reading this correctly or am I misunderstanding."

dd, correct, when you add a new deep, set it on top, but there is no need to reverse the boxes in a new hive, the queen will move up and down.  as others have said, reversing is normally done in the spring of the year.  also, as pete mentioned, one must be careful not to reverse hives with brood in both boxes.

i am not one to reverse my hives in spring, unless the queen does not move down. 
Title: Re: Reversing the deeps (brood boxes)
Post by: GLOCK on May 21, 2014, 03:53:16 pm
I do it all my hives in spring it's part of my SPM  and it works for me I even have one hive the queen just won't lay in the bottom box after 2 Reversing she seems to settled in but I have not checked on her since Reversing last time. But no swarms yet and last year I had none out of 10 DBL deeps.
Good luck. Just try it and see if it works for you   will learn your own way of doing things as time go's on.
Title: Re: Reversing the deeps (brood boxes)
Post by: LazyBkpr on May 22, 2014, 12:41:20 am
I use mediums so have three boxes. Reversing lets me clean everything and swap in some new frames and pull old ones. This gives me frames to start nucs or hives, puts the cluster at the bottom and opens the brood chamber to help restrict the desire to swarm until I can get queens to do splits.