gah... So I mentioned this to a friend, and it seems, he has CANNED coyote... (It is actually in jars) So that afternoon he made "coyote" and noodles, and I tried it, JUST, so I can say I did...
Well, I think I will have to load a few cartridges for the turtle gun. I was impressed.
Cabin fever is REALLY beginning to set in now.. I am down and out again.. for a couple days at least..
Sharpening the blades for my planer with a big sharpening stone..
I had the blade bolted to a table, sharp edge out, so I could run the stone across the edge.. it worked perfectly!!! Until my pinky finger sort of hung down a little and got scissored between the stone and the blade as I shoved the stone up across the edge...
Took the tip of my finger off, chipping the bone as the blade passed it..
Actually wasnt too bad, blade was sharp enough that it hurt a bit.. I had my daughter wrap it up with the standard paper towel and electrical tape, and went back to work.. finished sharpening, put the blades in the planer, shaved the 2x12's down to 1 3/8.... and the finger started to throb...
SO I went home and took aspirin, but the throbbing continued to get worse.....
Tied my hand to the headboard to keep it above my heart.. took sleeping meds, and some codine, slept about two hours... spent the next day REALLY hurting, and listening to everyone say, go to the doctor!!
For what? So he can use a brush and scrub out the wound and hurt me worse? NO!
Finally got some sleep last night, hand still tied to headboard.. I told my wife NOT to get any ideas..... it didnt work, she didnt get any ideas.... feel a bit better today, throbbing comes and goes... With luck, I will be back in the shop tomorrow so I can stop wearing holes in our floors here with all the pacing...