« previous next »
Pages: 1 2 [3]   Go Down

Author Topic: My first stab at frames today.  (Read 17318 times)

0 Members and 1 Guest are viewing this topic.

Offline LazyBkpr

  • Global Moderator
  • Gold Member
  • *******
  • Posts: 6842
  • Thanked: 205 times
  • Gender: Male
  • www.outyard.net
    • The Outyard
  • Location: Richland Iowa
Re: My first stab at frames today.
« Reply #40 on: May 04, 2015, 07:36:42 pm »
One 2x12x8 will make 40 top and bottom bars. A few more if none are ruined due to knots, a few less if there are a LOT of knots...
    so thats .31 cents for one top bar and bottom bar.

   One 2x12x8 will make 15 blocks to cut end bars from. Each block will make approximately 17 plates or side bars. So around 255 side bars per board = about 5 cents each. So that comes to around .36 cents, minus blades, router bit, electricity and thumbs..  oops, did I say thumbs?

Logged
Drinking RUM before noon makes you a PIRATE not an alcoholic!

*Sponsor*

Offline iddee

  • Administrator
  • Gold Member
  • *******
  • Posts: 6150
  • Thanked: 412 times
  • Gender: Male
  • Location: Sophia, N. C.
Re: My first stab at frames today.
« Reply #41 on: May 04, 2015, 08:05:48 pm »
You're paying 6.20 for the board. They are 8.59 here. Now re-figure the cost for here.
Logged
“Listen to the mustn'ts, child. Listen to the don'ts. Listen to the shouldn'ts, the impossibles, the won'ts. Listen to the never haves, then listen close to me... Anything can happen, child. Anything can be.”
― Shel Silverstein

Offline Perry

  • Global Moderator
  • Gold Member
  • *******
  • Posts: 7382
  • Thanked: 390 times
  • Gender: Male
    • Brandt's Bees
  • Location: Annapolis Valley, Nova Scotia
Re: My first stab at frames today.
« Reply #42 on: May 04, 2015, 08:30:10 pm »
Quote from: LazyBkpr on May 04, 2015, 07:36:42 pm
One 2x12x8 will make 40 top and bottom bars. A few more if none are ruined due to knots, a few less if there are a LOT of knots...
    so thats .31 cents for one top bar and bottom bar.

   One 2x12x8 will make 15 blocks to cut end bars from. Each block will make approximately 17 plates or side bars. So around 255 side bars per board = about 5 cents each. So that comes to around .36 cents, minus blades, router bit, electricity and thumbs..  oops, did I say thumbs?

Cost of the tip of ones thumb..............................Priceless! :laugh: :laugh: :laugh:
Logged
"It is not the man who has too little, but the man who craves more, that is poor."      
Forum Supporter
Pages: 1 2 [3]   Go Up
« previous next »